How to change the strings on the Jamstik Studio.
Tools Needed:
-Allen Key: 3mm Allen key provided in the Studio MIDI Guitar Gig Bag
-Magnetic Tuning Key: Provided in the bridge of the Studio MIDI Guitar
-String Cutter: Here's a basic one from Amazon that we like)*
-New Guitar Strings: Any metal strings will work just fine. The MIDI pickup is magnetic, so the guitar requires you to use metal strings rather than nylon. The Jamstik ships with 9s, but standard electric guitar strings will be compatible, so if you'd prefer to use 10s, you certainly can! Here's a link to our go-to strings on Amazon.
Video Instructions:
Step-by-step Instructions:
1. Remove the nut screws with the provided 3mm Allen key.
2. Grab the magnetic key from the bridge, and loosen the strings.
3. Clip the end of the old strings.
4. Gently pull to remove the strings
5. Slide the new string in through the nut.
6. Pull the string past the bridge, and snip about 1 inch past the bridge.
7. Kink the end of the string, and put it under the bottom of the bridge. Then start winding.
8. Finally, put the nut back on.
Common Questions:
Do you have to use special strings?
Any metal strings will work just fine. The MIDI pickup is magnetic, so the guitar requires you to use metal strings rather than nylon. We'd recommend following standard .010–.046 gauges. Slightly below or above this range should be fine, though it may require some sensitivity adjustments in the Jamstik Creator plugin.
Related Articles: -How to Adjust the nut height on the Jamstik Studio MIDI Guitar
*Amazon Affiliate Disclosure: If you purchase anything through the Amazon link above, Jamstik may earn a commission in return.
Comments
1 comment
Hey! It seems you missed a couple of important details in your re-stringing instructions above.
1) After clipping the strings and pulling them out, don’t you also need to tell people to remove the ends from the bridge before inserting the new strings?
2) It would also help to advise people how to line up those holes in the bridge and to partially insert the string end into each hole before winding, as well as guiding the strings so they stay centered won’t be leaning against the sides of the brass — otherwise the strings will make that plinking noise because they’re getting partially muted since they can’t ring out freely.
Hope this added info helps some people out there!
Please sign in to leave a comment.