Jamstik MIDI Guitar Firmware Release Notes

Firmware Version 3.66 

Fixes issue where Jamstik would not fully power down

Reduces PCB noise

 

Firmware Version 3.62 

Fix to USB disconnects

 

Firmware Version 3.22 

Flash power button LED when profile changes 

Improvements to pitch bend smoothing

 

Firmware Version 3.20 

Implement settings profiles (currently read-only) 

Add SysEx commands for sending a list of profile names from the Jamstik to a receiver 

Enhance sysex config protocol to add support for transmitting ASCII strings 

Add ____NAME parameter for working profile name 

Add PROFILE_ parameter for last selected profile index 

SysEx parameter getters no longer reset activity timer 

Add demo mode with config parameters DEMO__EN (enabled), DEMO_TIM (reset timer in seconds), DEMO_PRF (reset profile)

 

Firmware Version 3.18 

Fixed bugs causing notes on the wrong channel in single-channel mode 

Add string ID CC message & parameter (STRINGID) 

Send pitch bend message before note-on in multi-channel & MPE modes

 

Firmware Version 3.16 

Broadcast battery level every 5 minutes via MIDI SysEx"

 

Firmware Version 3.15 

Dramatically reduce double triggers, octave errors and other unwanted notes 

Reduced latency in some cases 

Improved note-on accuracy 

Improved legato tracking 

Pitch tracking works at lower volumes than before 

Do not send pitch bend while muting 

Add transcription mode 

Fix issue where notes below fret 0 were not sent

 

Firmware Version 3.11 

Fixed issue with starting bluetooth module

 

Firmware Version 3.10 

Fixed issue with USB enumerating before the DSP was available

 

Firmware Version 3.09 

Fixed issue with clean shutdown

 

Firmware Version 3.08 

Fixed issue with bluetooth connectivity 

Added ability to map string envelope to other controllers, or channel pressure 

When string envelope is mapped to a control change, send the LSB when possible 

Optimized string envelope to avoid sending the same value twice

 

Firmware Version 3.06 

Fixed issue with firmware update corrupting some settings 

Fixed issue with bluetooth module not disabling correctly

 

Firmware Version 3.04 

Fixed problem with mis-reported battery charge percent

 

Firmware Version 3.03 

Default pitch bend range in MPE mode is now 48 

Default pitch bend range in other modes is now 2 

Improved support for MPE

 

Firmware Version 3.01 

Improved factory test procedures

 

Firmware Version 2.14 

Jamstik Studio sends lefty mode as part of its allconfig routine

 

Firmware Version 2.13 

USB communication bug fix

 

Firmware Version 2.12 

Separate sleep timers for battery vs plugged in 

Double-press power button toggles MIDI mode 

Added second set of MIDI ports for config communications (USB only) 

Protect against sleep timers <5 minutes

 

Firmware Version 2.04 

Companion strings processor update  

Added support for changing pitch bend range 

Tweaks the sensitivity settings (lower sensitivities are even less sensitive than before)

 

Firmware Version 2.02 

First firmware publicly available with this firmware updater 

Communicate open note tuning to signal processor 

Bug fix in calculating fret 

Receive open note tuning from main processor 

Adjust pick detection algorithm parameters when tuning changes

 

Firmware Version 1.45 

Fix bug in restarting after updating over bluetooth. 

Fix bug in USB disconnect/reconnect